Widget HTML Atas

Ford Expedition 2005 Cam Sensor Wiring Diagram

P0345 Camshaft Position Sensor Circuit Malfunction Bank 2

Technical Description

Camshaft Position Sensor A Circuit Malfunction (Bank 2)

What does that mean?

This diagnostic trouble code (DTC) is a generic powertrain code. It is considered generic because it applies to all makes and models of vehicles (1996-newer), although specific repair steps may be slightly different depending on the model.

This indicates that a problem was detected in the camshaft position sensor circuit of bank 2.

Since it says circuit, that means the problem could lie in any part of the circuit - the sensor itself, the wiring, or the PCM. Don't just replace the CPS (camshaft position sensor) and think that will definitely fix it.

Symptoms

Symptoms can include:

  • Hard starting or no start
  • Rough running / misfiring
  • Loss of engine power

Causes

A code P0345 could mean one or more of the following has happened:

  • a wire or connector in the circuit could be grounded/shorted/broken
  • the camshaft position sensor may have failed
  • the PCM may have failed
  • there exists an open circuit
  • the crankshaft position sensor may have failed

Possible Solutions

With a P0345 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:

  • Visually inspect all the wiring and connectors in the circuit
  • Check for continuity in the circuit wiring
  • Check the operation (voltage) of the camshaft position sensor
  • Replace the camshaft position sensor as required
  • Check the crankshaft position circuit as well
  • Replace circuit wiring and/or connectors as required
  • Diagnose/replace the PCM as required

Related DTC Discussions

  • 2006 Ford Expedition p0345, p0349 code trouble
    Hi new here so sorry if I make any mistakes or get any terminology incorrect. I'm having issues with my 06 expedition limited i'm getting p0345, p0349 codes that just wont go away. I replaced the cam phasers on both sides used the special wedge tool for the chain, marked the chain in reference to wh...
  • 2006 f150 sounds like a diesel p0340 p0345 p0012
    i have an 06 f 150 5.4l , sounds like a desiel engine while running. ran obd and got cam sensor codes. both were changed but it still runs the same. codes were p0340,p0345,p0012. any help would be appreachated...
  • P0345 and P0139
    Hi, first post here. Hoping for some advice. On my 2006 Cadillac XLR, with the standard 4.6L NorthStar V-8, I got a check engine light, but no warnings on the Driver Information Center (DIC). The car only has some 42,200 miles on it, and is running/starting just fine. I have read what has been p...
  • P0305,p0345,p0022
    [url][/url]...
  • 2008 ford f250 camshaft sensor check code p0345
    engine light came on check code was p0345 which is a camshaft sensor wondering if I can drive truck with the that being the problem please help...
  • P0300,P0301,P0022,P0345 on 2005 F-150
    Hello, have a 2005 F150 5.4L 4x4 that has started idling low, running rough, sometimes but not constantly stalling at idle (engine starts knocking and sputtering) and just seems to lack power after 55mph. Triggers CEL and has these codes: P0022, P0301, P0300, P0301 (twice) and P0345. Engine has 16...
  • P0345 Toyota Sienna 2007
    Hello! My check engine light goes on and than turn off....a few times. I got someone to read the code and got a P0345. Can I still drive my VAN or this can cause damages? I'm about to leave for a week of vacation and it is of course Saturday 16:45 and all the garages are closed :-( Thanks for...
  • 2005 Expedition 5.4L Triton - P0345, P0349, P0420 - HELP!
    Hi all. I'm new to this site so please forgive me in advance! We purchased a 2005 expedition with 115k miles. The check charging system light is illuminated and now the check engine light is on. We had the codes ran and at first threw a misfire on cylinder 1 and also a P0345 and P0349. So we replace...
  • 2004 Ford F150 FX4 5.4 P0606 P2106 P0345
    I have a 2004 F150 Fx4 with the 5.4 motor. it has 183k miles. I changed the timing chains and tensioners. put it all back together now im getting 3 codes. P0606 pcm processor fault. P2106 throttle actuator limited power, and P0345 camshaft position sensor circuit failure. Can someone tell me what al...
  • p0345 Nissan Pathfinder
    Nissan adam 2006 4.0 pathfinder 89000 miles I am back -after a new timing chain and tensioners and timing solenoids -all new gallery gaskets . and all 3 sensors changed out .the p0011 and p0021 codes are gone ..today the car died again . stalled just as before . this time I am getting p0345 . we ...

Need more help with a p0345 code?

If you still need help regarding the P0345 trouble code, please post your question in our FREE car repair forums.

NOTE: This information is presented for information purposes only. It is not intended as repair advice and we are not responsible for any actions you take on any vehicle. All information on this site is copyright protected.

Posted by: tannermanista.blogspot.com

Source: https://www.obd-codes.com/p0345